- Two-Pack Surface Applied Damp Proof Membrane
- Allows Rapid Application Of Screeds & Coatings
- Ideal For Carpets, Tiles, Vinyl & Wood
- Use Where Damp Proof Membrane Is Ineffective
- Apply By Brush, Roller & Trowel
- Excellent Adhesion
- Clear & Stirling Grey Finish Available
Resuprime MVT is a two-pack surface applied damp proof membrane that enables earlier application of industrial resin flooring screeds, coatings and other floor coverings to be applied onto new concrete sooner than the normal time required for concrete to dry.
Formerly known as 'R.S.Dampshield FH', Resuprime MVT is easily applied by brush, roller or trowel edge.
It is ideal for carpets, tiles, vinyl and wood and for resin coatings.
The two-component epoxy resin primer is solvent-free, low-odour and has excellent adhesion.
It is also used for existing concrete slabs where there is no damp proof membrane or where a degree of moisture tolerance is required for a resin floor system being installed.
Recoating can take place after six to eight hours or once the surface has lost tackiness. For light traffic areas, wait 18-24 hours; full traffic should be 48-72 hours and full chemical cure is seven days.
Theoretical coverage rate is 23m² @ 200µm for 5kg.
Full product data sheets and safety data sheets are available on request.
Product Benefits
- Product benefits
- Easy application
- Application onto substrates with hygrometer readings up to 97%
- Solvent-free
- Low odour
- Excellent adhesion
Surface Preparation
New concrete must be clean, sound, dry, fully cured and surface laitance removed by vacuum enclosed shot blasting or mechanical grinding, a minimum strength of 25N/mm² is required.
For existing concrete floors, remove all dirt, oil, grease, old paint or any other surface contaminants by vacuum enclosed shot blasting, scarifying or mechanical grinding.
Fats, oils or greases must be removed by mechanical means and detergent washing and making sure all residue of detergent is washed and removed by rinsing with clean water. Local repairs should be carried out using Resuscreed PA.
Previously coated floor must have all coatings and loose floor paints removed by mechanical preparation, then primed.
If the old resin flooring cannot be removed then please consult with our technical team for advice on intercoat adhesion and suitability, as it may not be compatible with the existing floor coating.
Where Resuprime MVT is applied to masonry/concrete surfaces, care must be taken to ensure that surface preparation is thorough but does not disfigure the surface.
Application
Mix the entire contents of the base with the hardener. If a separate mixing bucket is being used mix thoroughly ensuring all contents of both components are removed from the buckets supplied.
Using a slow speed electric mixer, mix for approximately two to three minutes until the two components are fully combined.
The mixed unit should be applied immediately by roller, brush or squeegee with a consistent procedure. Floor areas should be cross-rolled to ensure even application and to minimise roller marks.
APPLICATION CONDITIONS
The ambient temperatures of the areas should not be allowed to fall below 15°C throughout the application and the curing period, as this could have an adverse effect on the appearance and colour of the system. Surface temperature must be above 10°C.
Where possible it is recommended that the application area is heated to a minimum temperature of 15°C. Ideally to allow the ambient and substrate temperature to stabilise prior to the installation.
Download Product Data Sheet (PDS_SW_Resuprime_MVT.pdf)
Download Product Data Sheet (PDS_SW_Resuprime_MVT.pdf)
Download Safety Data Sheet (SW_SDS_Resuprime_MVT.pdf)
Download Safety Data Sheet (SW_SDS_Resuprime_MVT.pdf)
Payment & Security
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.