- Two-Pack Water-Based Epoxy Resin
- Clear Gloss Finish
- Excellent For Previously Painted Surfaces
- Can Be Used On Concrete, Plaster, Brick, Blockwork & Ceramic Tiles
- Resistance To Light Chemical Attack
- Prevents Fungus Or Bacterial Growth
- Ideal For Food Prep Areas & Laboratories
- Suitable For Operating Theatres & Breweries
- Great For Custody Suites & Automotive Workshops
Resuseal Wall is a two-pack water-based epoxy resin wall coating for durable, seamless finishes.
Providing excellent resistance to light chemical attack, Resuseal wall coatings also do not support fungus or bacterial growth.
This resin coating is primarily designed for application in food preparation, laboratory-clean room environments and other areas of maximum hygiene, such as operating theatres and breweries.
It is suitable for concrete, plaster, brick, blockwork and ceramic tiles.
Ideal as a coating for previously painted surfaces, such as automotive workshops.
Recoating can take place after 12 - 24 hours. For light traffic areas it is 24 - 48 hours; full traffic 48 - 72 hours and a full chemical cure after 7 - 10 days.
Theoretical coverage rate is 37m2 @ 100 microns wet thickness for 5kg.
Full product data sheets and safety data sheets are available on request.
- Superior colour stability
- Superior curing at low temperature
- Freeze-thaw stability
- Low odour
- Superb adhesion
Surfaces to be coated must be clean, sound, dry and free of any contaminants that could impair good adhesion.
Hard smooth surfaces should be abraded or sanded to provide a mechanical key.
Where open block work is to be coated this should be filled and bag rubbed with a sand cement mix to create a continuous, smooth paintable surface.
Substrate temperature should be between 10-30oC with relative air humidity of 70% maximum.
Cold, high humidity and lack of air movement can cause a patchy finish, gloss reduction and delay in curing and damage to final properties.
To prevent this, ensure good drying conditions and air ventilation prevail throughout the application and cure of the product.
Open and porous substrates will require priming. Resuseal WB Clear is recommended and depending on the porosity and texture of the surface to be primed may require two coats.
Resuseal WB Clear will not seal block work as it is a thin film primer.
Pre-mix the base component to a uniform consistency then add the entire contents of the hardener to the base and mix by using a slow speed handheld powered mixer and mixing paddle for approximately two to three minutes to achieve a consistent mixture. Note: Do not use a separate mixing bucket as it may affect the mixing ratio.
The mixed unit should be applied immediately by roller or brush with a consistent procedure, cross-rolling to ensure even application and to minimise roller marks.
Coverage rates will depend on the porosity of the substrate. Do not add water to this product. Do not apply Resuseal WB Wall Gloss on top of polyurethane coatings, as it may not adhere properly.
Payment & Security
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.